Maintenance And Care - TKS R2 Operator's Manual And Spare Parts List

TKS

14 Maintenance and care

NB!
Always pull out the plug before inspecting,
maintaining or repairing the machine.
• Remove any remaining material fromthe
conveyor belt and spreader unit daily.
This can also be removed using compressed
air.
• Clean the conveyor belt, chain wheels,
shafts and bearing shields as and when
necessary and at least once a week.
IMPORTANT!
• Do not tighten the conveyor belt to tight or
askew. Ensure that drive chains are also
kept tight. Check them regularly for slack or
damage.
• Fotlager og kjeder smøres hver 24. drifts-
timer eller minst en gang i uken.
• Ensure that electrical equipment is not sub-
jected to excessive temperaturefluctuations.
This can lead to condensation and short
circuits.
• The oil in the worm gears should not be
exposed to temperatures below minus
30 degrees C. If the machine needs to run
normally at below -30o C, contact the
manufacturer for advice andguidance.
• NB! Keep the machine clean of dust, as this
constitutes a fire hazard. It is important to
clean the machine's spreading discs,
conveyor belt and rear shields once a week.
TKS recommends cleaning with compressed
air rather than using a high pressure washer.
53