TKS FeedBelt Assembly Instruction

1
a
b
2
Max 4 mm
3
RIKTIG
CORRECT
GALT
WRONG
4
a
b
5
80
0,6 m
a
Assembly instruction – wire

IMPORTANT!

Read the whole instructions and do the following in the set order:
• Faults and damage caused by not following these instructions will NOT be
covered by the TKS warranty.
• If transport damage is discovered on wires before installation,
please contact TKS.
DO NOT fi t wires without end caps (a) or wraps (b)

Preparation:

• Place the rake at the fi lling end.
• Damaged wire must be removed.
• Retain the wire clips to fi t new wires.

Control:

• Wire discs; drives/reverses, must be checked for damage before

installation.

• Use the attached feeler gauge to see whether there is wear on the discs.
• Max 4 mm gap from the tip of the feeler gauge to the bottom of the disc.
• Discs must be replaced if they are seriously damaged.

Handling:

• Be careful when handling wires.
• Wires must not be drawn out from the end of the reel.
Tightened snags damage the wire permanently.
• The reel is placed on a storage stand on which it can rotate.
• The wire must be unwound from the reel horizontally.
• Very important! Unwind the wire from the bottom reel to the bottom disc.
(Alternatively, from the top reel to the top disc).
• Keep the wire taut when unwinding.
• Avoid gravel and sand on the steel rope. This will aff ect the service life of
the wire.
• NB! Joining new and damaged wires for pulling is NOT permitted.
a
Installation:
• Place the reel at the fi lling end and unwind the wire from the
bottom of the reel.
• Insert wire end (a) into the guide blocks.
• Wind the wire around the turn disc.
• Pull the wire towards the drive disc.
• Pull the wire completely off the reel.
• Wind the wire end (b) around the drive disc.
• Form a loop at end (b) 120 mm free end outside the wire clip.
• Tighten the rope and place the loop on end (a) approx. 0.6 m away from
the fi rst loop.
80
120
• Fit the wire clip and tighten.
• Tighten the wire using the tightening tool and screw the clip tightly to the
tightening rod.
b
• See the Assembly instructions for FeedBelt for detailed instructions
FeedBelt
988865