Download Print this page

Running-In Your Speakers; Product Specific Instructions - Monitor Audio Apex 10 Initial Setup Manual

Loudspeaker and subwoofer
Hide thumbs Also See for Apex 10:

Advertisement

•,
,
,.
?,."--:,h-:,· ..
../',,~,':i"
~
.
,,,,· •'
.
0
1 . Side
surround
speakers
2.
Rear surround
speakers
A 7 .1
surround
system
will make use of side
(position 1) and rear
speakers
(position
2)
to create a full
360°
soundstage, if setting up
a 5 .1 system you can
place your surrounds in
position
(1)
or (2).
0
,
- -
0
~--•-------•---
Running-In Your Speakers
For information on Dolby
Atmos please refer to the
manual for your in ceiling
speakers or the Monitor
Audio web site.
Run your speakers in by playing normal music at low-mid listening levels for approximately 50-70 hours
play time. You may find the sound will continue to improve even after 70 hours.
This
can be done naturally over time: like a fine wine the performance will
improve
with age.
Alternatively if you wish to run the speakers continuously on loop you can decrease the audible volume/
presence by placing the speakers face-to-face so that the drivers/tweeters are directly aligned and
as close as possible. Then connect the amplifier to your speakers so that one is as normal (in phase):
positive to positive and negative to negative (red to red and black to black), and the other speaker out of
phase: positive to negative and negative to positive inputs on the speaker.
Product Specific Instructions
For a full, range specific manual and further information on the mounting, wiring, port bungs and product
information, please visit the product page at monitoraudio.com
monitoraudio.com
3

Advertisement

loading

This manual is also suitable for:

Apex 40Apex aw-12