Advertisement
Connecting to a Stereo Amp ifier
Stereo L & R input may be required if using a 2-channel stereo amplifier, or an amplifier with no LFE
output. Connect 2 x interconnect cables (left and right) from the amplifier to connections marked
L
& R.
With the
pre/
integrated amplifier set to a low level, set the subwoofer up using the suggested guide
below before playing any
music/
test tones.
•
Set the volume to around 10 o'clock
•
Frequency should be set in accordance to your main speakers
•
Phase to O
Now play some familiar music and gradually adjust the volume
and/
or the frequency
until
happy with the
integration and balance of the sub woofer with the rest of the
system.
Louasoeaker Pos1tionJ0.9
2 Channel Positioning
When arranging a 2 channel system, the listening position and the loudspeakers should form an
equilateral
triangle.
The speakers should be positioned approximately 6 - 1 O feet (1 .8 - 3m) apart. The
ideal distance from the rear wall varies depending on the speaker and tastes, however, they need to be a
minimum of 3 feet (91 cm) from the side walls.
Experimentation is strongly advised when initially setting up the speakers, as environment and personal
preference differ with every installation. If there is insufficient bass for example, try moving your speakers
closer to a wall. The opposite approach is recommended if there is excess
bass.
Alternatively, if this
isn't possible, the port bungs (where suppplied) can help reduce the excessive bass. If stereo imaging
is being lost, try 'toeing' them in slightly. The sound should appear to originate from the centre point
between the speakers, not the actual speakers themselves.
AV Pos1t.oning
Please refer to the illustrations opposite for the ideal angles and positions of each speaker in your
surround
system.
The speakers should be distanced from the wall according to the speaker and
personal preference.
If the sound is too bass heavy or there is bass boom from the room when playing music (without a
subwoofer). try moving the loudspeakers slightly further away from the
wall(s).
If this is not possible, try
adjusting the crossover frequency settings for the speakers and/or sub or changing the subwoofer's
position.
Front Speakers
The centre channel can be placed either above or below the TV screen, and as close as possible. If
positioned in a cabinet or sitting on top of the
TV,
ensure that the front edge is aligned with the front
edge of the TV or shelf. Where possible, the height of the centre channels' tweeter should be close to
the height of the front speakers' tweeter - ideally, within about 600mm.
Surround Speakers
Surround speakers should be placed high enough so that the drivers do not fire directly at ear level when
sitting down - one rule of thumb is to place them at ear level while standing, to avoid overpowering
the front speakers. If the surrounds are mounted on brackets on the side
walls,
experiment with aiming
them.
2
Loudspeaker and Subwoofer Initial Set Up Guide
Advertisement
