Customization - Canon RC-V100 Instruction Manual

Customization

You can personalize various aspects of the remote controller's operation, including the
brightness of buttons and indicators and the dials' direction, to your preference.
Micro
Category
switch
A-1 Dials' Direction
A-2
A-3
A-4
A-5
A-6
A-7 Dials' Sensitivity
A-8
B-1
B-2 Dials' Mode
B-3
B-4
B-5 Buttons/Indicators
B-6
B-7 Sound
B-8 Reserved for service/maintenance
* PAINT-group dials: KNEE POINT dial, KNEE SLOPE dial, BLACK GAMMA LEVEL dial, SHARPNESS
LEVEL dial.
** WB/MB group dials: WHITE BALANCE R dial, WHITE BALANCE B dial, MASTER BLACK R dial, MASTER
BLACK B dial.
About the dial modes
You can set the various dials' mode to absolute or relative.
In relative mode, the value is adjusted according to the difference between the dial's
position before the change and its position after the change. In relative mode, the
position of the dial does not reflect the current value of the setting being adjusted.
In absolute mode, the position of the dial always corresponds to the current value of
the setting being adjusted. The dial's center position (where it clicks) represents the
setting's standard value and the dial's end positions correspond to the setting's
maximum and minimum values.
NOTES
• When a dial is set to relative mode, the adjustment range may be narrowed
depending on the initial position of the dial when it was activated.
Content
PAINT-group* dials' direction
WB/MB-group** dials' direction
ZOOM dial direction
FOCUS dial direction
MASTER PEDESTAL dial direction
IRIS dial direction
IRIS dial sensitivity
FOCUS dial sensitivity
All other dials' sensitivity
PAINT-group* dials' mode
WB/MB-group** dials' mode
MASTER PEDESTAL dial mode
Lamps active
Brightness
Operating sounds
Micro Switch Position
ON OFF
Reverse Normal
Reverse Normal
Reverse Normal
Reverse Normal
Reverse Normal
Reverse Normal
Low High
Low High
Low High
Absolute Relative
Absolute Relative
Absolute Relative
Off On
Dim Bright
Off On
— —
En
19