Page 2
Please keep this Owner’s Manual for future reference. It contains helpful information on how to maintain and care for your APEC Green Carbon Water Conditioner. Thank you for choosing APEC Green Carbon Premium Water System. Please read and become familiar with instructions and parts needed before proceeding with the installation. Copyright: This manual is copyrighted by APEC Inc.
Page 3
Parts List for Green Carbon Conditioning System Installation Kit (2 packages): Package #1: Media tank and filter system installation kit. Bypass Valve V3007-02LF kit includes: Brass Sweat Adapter Kit 1” Quick Connect Plastic Split Rings Rubber O-rings V3007 kit includes: 1”...
Page 4
Green Carbon Sytem Media Flush kit: 1 each 3/4” FHT x 3/4” MPT x 1/2” FPTB 1 each 1” Dura Coupling 1 each 1” MPT x 3/4” FPT Garden Hose Brass Adapter (A-679) FPT PVC Adapter (D2466) PVC Dura Bushing (D2464) Media tank: Funnel Tank with In/Out Valve...
Product Operation and Specifications Rated Service Flow (GPM): • GreenCarbon- 10 8-10 GPM • GreenCarbon- 15 10-15 GPM Rated Capacity (Gallons): • Holds 9.1 Gallons in the GreenCarbon- 10 Tank • Holds 16.7 Gallons in the GreenCarbon-15 Tank Minimum Working Pressure (PSIG): 25 PSI Operating Temperatures: 36-120 Degrees Fahrenheit pH Range: 7-11 pH Plumbers Notice:...
Page 6
Preparing tank for installation instructions. Please follow installation steps below: Safety Instructions IMPORTANT! • Wear proper eye protection (ex. tightly fitting safety goggles), face mask, hand gloves, protective clothing, etc when installing water treatment media into tank for installation. • Wash your hands and face after installation. •...
System Installation: This is an overview for the system installation. Wall OUT GOING WATER TO HOUSE INCOMING WATER SUPPLY Shut O Valve Whole House Filters INPUT OUTPUT Figure. 1 Turn off water supply where it enters the building. Install a shut off valve (if needed) then install the Whole House Sediment Filter in the vertical position.
Page 8
Flushing the Carbon in the Carbon Tank: Use provided parts V3007, D2466, D2464, A-679. Once the media tank is installed on the main water pipe, you must Flush Out the Carbon media for 10-15 minutes or until the water runs clear. To flush the media turn the Bypass Valve to Normal Operation Mode.
Page 9
Carbon Tank Installation The bypass valve comes complete with O-rings, split rings and black quick connector nuts. Install the bypass valve by pressing the valve onto the head of the tank and hand tighten both black quick connect nuts. When running the piping for the Green Carbon Water Conditioner, connect the incoming water supply to the DOWN-FLOW INLET (Input) side.
Page 10
Bypass Valve Operation Mode Normal Operation Mode: Water flows through the Bypass Valve and into the Green Carbon Conditioner supplying treated water into the house. (See Figure 5) OUT GOING WATER TO HOUSE INCOMING WATER SUPPLY INPUT OUTPUT Figure. 5 Bypass Operation Mode: Water flows through the Bypass Valve without entering the Green Carbon Conditioner and the water entering the house is untreated.
Page 11
Carbon Conditioner Overview 1. During the carbon flush, the pressure can start to drop off. If this happen, turn off the water and let the tank sit about 30 minutes to allow the carbon to settle down off of the basket inside the tank.
WARRANTY POLICY For a period of ten years from the date of original purchase, APEC will replace any part of the filter housing, tank heads, and the bypass valves that APEC finds to be defective in operation due to faulty materials or workmanship with the exception of the replaceable media, which shall be prorated.
Page 13
Advanced Purification Engineering Corp. 1320 S Johnson Drive City of Industry, CA 91745 For questions or comments please visit our website at: www.FreeDrinkingWater.com For technical support contact us at: Techsupport@freedrinkingwater.com 1-800-880-4808...
Need help?
Do you have a question about the GREEN CARBON Series and is the answer not in the manual?
Questions and answers