Outdoor GreatRoom Company Sierra Installation Instructions Manual
Fire pit tables
Hide thumbs
Also See for Sierra:
- Installation instructions manual (12 pages) ,
- Installation instructions manual (12 pages) ,
- Manual (11 pages)
Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Outdoor GreatRoom Company Sierra
Summary of Contents for Outdoor GreatRoom Company Sierra
- Page 1 Fire Pit Tables Sierra and Grandstone Installation Instructions P a g e...
-
Page 2: Table Of Contents
Contents Contents……………………………………..2 Required Tools….………………………..3 Placing the Table…………………..……4 Gas Connection…………………….…….5 Igniter Installation…………….………...6 Placing the Top…………………………...7 Burner Installation……………………….8 Locating Propane tank………………...9 Door Installation………………………...10 Notice: This unit is listed for use in North America for both residential and commercial applications. In the event that the appliance can be used by those unfamiliar with the appliance, we suggest the use of a master Key Valve to prevent unauthorized use. -
Page 3: Required Tools
Required Tools Utility Knife To cut and remove packaging 2 Open Ended Wrenches To make gas connections Leather Gloves To protect hands from rough edges found on the coffee table. One (1) AAA Battery (not included) Required for igniter installation for Crystal Fire burners. - Page 4 4. When locating your coffee table, refer to the Crystal Fire manual and maintain clearance to combustibles. Sierra fire pit table shown, finishes and styles may vary Before completing the following steps, read and understand the Crystal Fire owner’s manual.
-
Page 5: Gas Connection
Gas Connection 1. Connect the incoming black rubber gas hose to the valve. It is not recommended to use Teflon tape or pipe dope on the connection to the valve with flare fittings. LP installations use the hose and regulator provided with the burner. -
Page 6: Igniter Installation
Igniter Installation Note: Before installing ignition system, ensure that gas valves are closed and gas is disconnected for safety. 1. Make sure the valve is in the OFF position 2. Unscrew sparker cap and hex nut (sparker included with burner). Install as shown below. P a g e... - Page 7 3. To properly install ignition system, an Ignition and Ground wire need to be attached to the igniter box. Start by plugging the black Ignition wire hanging from the burner in to one side of the back of the igniter (either side is fine).
-
Page 8: Placing The Top
Placing the top 1. With the help of at least one other person, remove concrete, granite, or tile top from packaging and gently lower on to your fire pit table base. Construction adhesive or silicone may be used on the top of the base for a more stable and permanent placement in heavy use areas. -
Page 9: Door Installation
Door Installation Door support Set door on supports and close. Magnet will hold door in closed position. IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to hooking up your burner, including safety information, proper tightening of connections with two wrenches and full burner setup and lighting instructions. - Page 10 ENTIONALLY LEFT AWESOME. Warranty: Fire pit tables are covered under a 1- year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/warranty-form to register your product. 14400 Southcross Drive West • Suite 100 • Burnsville, MN 55306 Toll Free: 1-866-303-4028 • Sales@OutdoorRooms.com 10 | P a g e...
- Page 11 Notes: _________________________ _________________________ _________________________ _________________________ _________________________ _________________________ _________________________ _________________________ _________________________ _______________ 11 | P a g e...
- Page 12 © 2015 The Outdoor GreatRoom Company 12 | P a g e...
Need help?
Do you have a question about the Sierra and is the answer not in the manual?
Questions and answers