Download Print this page

Number 8 JS-HH15A Manual page 9

Advertisement

Description
Coating Materials Suitable for Use
Water- and solvent-based paints, fnishes, primers, 2-component paints, clear fnishes,
automotive fnishes, staining sealers and wood sealer-preservatives.
Coating Materials Not Suitable for Use
Wall paints (emulsion paints) etc., alkali and acidic paints. Coating materials with a fash
point below 55°C.
Preparation of the Coating Material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that
are undiluted or slightly diluted.
1. Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes
Wood preservatives, mordants, oils,
disinfection agents, plant protective agents
Paints containing solvents and water-
soluble
paints, primers, vehicle coating paints,
hick-flm glazes
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfills your requirements.
FIG.2
A
undiluted
undiluted
dilute by 5 - 10%
B
8

Hide quick links:

Advertisement

loading
Need help?

Need help?

Do you have a question about the JS-HH15A and is the answer not in the manual?

Questions and answers

Noeline
January 24, 2025

I have setup as per direction s however it is not spraying

1 comments:
Mr. Anderson
February 10, 2025

The JS-HH15A spray gun may not be spraying due to several possible reasons:

1. Incorrect Suction Tube Position – Ensure the suction tube is properly aligned. If spraying overhead, turn the tube rearwards; if spraying on a flat surface, turn it forwards.
2. Thick Paint or Clogged Nozzle – If the material is too thick, dilute it by 5-10% step-by-step until the flow rate meets requirements.
3. Low Convey Capacity – If the spray output is too low, gradually add dilution to improve flow.
4. Power Supply Issue – Ensure the mains supply voltage matches the rating plate (230-240V).
5. Blocked or Dirty Components – Clean the spray nozzle and suction tube to remove any obstructions.

Checking these factors should help resolve the spraying issue.

This answer is automatically generated

This manual is also suitable for:

322789
Save PDF