Cisco ASR 920 Series Manual page 35

Installing the Cisco ASR 920 Series Router
Connect Cable to Copper Gigabit Ethernet Port
The device interface modules support RJ-45 and Ethernet SFP ports.
The RJ-45 port supports standard straight-through and crossover Category 5 unshielded twisted-pair (UTP)
cables. Cisco does not supply Category 5 UTP cables. These cables are available commercially.
SUMMARY STEPS
1. Confirm that the device is powered off.
2. Connect one end of the cable to the Gigabit Ethernet port on the device.
3. Connect the other end to the BTS patch or demarcation panel at your site.
DETAILED STEPS
Step 1 Confirm that the device is powered off.
Step 2
Connect one end of the cable to the Gigabit Ethernet port on the device.
Step 3 Connect the other end to the BTS patch or demarcation panel at your site.
You have successfully installed the device and you are now ready to carry out a basic device configuration.
Connect Cables to SFP Modules
For information on connecting cables to Cisco optical and Ethernet SFP interfaces, see:
http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html.
Connector and Cable Specifications
For more information on cable specifications and pinouts, see
Connect Cable to Copper Gigabit Ethernet Port
Chapter 5, "Troubleshooting"
Installing the Cisco ASR 920 Series Router
.
35