Advertisement
INSTRUCTION MANUAL
When the log is supported on both ends, as illustrated, cut 1/3 the diameter from the top overbuck. Then
make the finished cut by under bucking the lower 2/3 to meet the first cut.
When bucking on a slope always stand on the uphill side of the log, as illustrated. When "cutting through", to
maintain complete control, release the cutting pressure near the end of the cut without relaxing your grip on
the chainsaw handles. Don't let the chain contact the ground. After completing the cut, wait for the saw chain
to stop, before you move the chainsaw. Always stop the motor before moving from tree to tree.
MAINTENANCE, CLEANING & STORAGE
Before any maintenance or cleaning operation is undertaken, ensure the mains plug is removed from the
Improper maintenance & storage of the machine may void your warranty.
MAINTENANCE
•
Before each use, check all nuts & bolts to be sure they are sufficiently tightened.
Regularly check for obvious defects such as loose, dislodged or damaged chain and guide bar, loose fixings
•
and worn or damaged components.
•
Check that covers and guards are undamaged and correctly fitted. Carry out necessary maintenance or
repairs before using the chainsaw.
•
Ensure the breather openings on the motor casing are open and clean from debris. If they are blocked, the
motor could overheat and shut the machine down.
•
We recommend only manufacturer original parts are used when maintaining this machine. Failure to do so
could invalidate your manufacturer's warranty.
REPLACING/CHANGING CHAIN & GUIDE BAR
Fit the chain and guide bar as described in "Assembly and Tensioning Chain".
The circular groove of the guide bar will wear particularly on the lower edge with time. When replacing the
chain, turn the chain bar 180° to allow even wear, thus extending chain bar life.
Check the drive sprocket. If it is worn out or damaged due to strain, have it exchanged by an authorised service
dealer.
If the chain bar is worn out or damaged, take the chain tensioning catch off the bar by losing the screw anti-
clockwise. Then fit the tensioning catch onto the new bar by tightening the screw clockwise. The catch
protrudes (a) must be fitted into the bar hole.
WARNING
wall socket.
Keep the machine clean for better and safer performance.
Advertisement
