Danby DDR050BJPWDB Quick Start Manual

QUICK-START GUIDE
DDR050BJPWDB | DDR050BJPWDB-6
SETUP

UNBOX THE DEHUMIDIFIER

Take out the device from its packaging and
allow to stand upright for 6 hours particularly
if the device was placed on its back or side.
Connect the power cord buckle in the bucket
to the back of the unit.
Open water bucket, remove the tape or
Styrofoam from bucket float. (Unit will not
work otherwise).
2

POSITIONING THE DEHUMIDIFIER

Ensure that the device is placed on a smooth,
level floor that is strong enough to support the
appliance with a full bucket of water.
Allow at least 20cm of air space on all sides of
the unit for good air circulation (at least 40cm
of air space on air outlet).
For e ectiveness, this is to be used in enclosed
spaces only.
3
Take out the water bucket and remove accessories
that might be contained in the bucket. Remove tapes
or Styrofoam (where applicable) from bucket float.
(Unit will not work otherwise)
A C C E S S O R I E S
Pump drain hose
Direct drain connector
Call us 1-800-263-2629
consumerservice@danby.com
FOR DEHUMIDIFIERS:
Power cord buckle
Direct drain hose
(flexible PVC hose)