Placing Your Tv On The System; Sample System Placement; Turning Off Your Tv Speakers; Powering On The System - Bose Solo 15 II Series Owner's Manual

Setting up the System

Placing your TV on the system

Lift your TV and place it on top of the system. Follow these
guidelines:
• The Bose Solo 15/10 series II system is designed to fit under TVs
that weigh no more than 75 lbs (34 kg) and have bases no wider
than 24" (61 cm), and no deeper than 12.25" (31 cm).
• The base of your TV should be centered on the top of the system
and must not hang over any of its edges.
• If the TV base is too large to fit on top of the system, place the
sound system in another location such as on an open shelf under
the TV, but keep it close to your TV so the audio cable will reach.
You can also mount your TV on the wall above the system.
CAUTIONS:
• DO NOT place a CRT type TV on this system. It is not designed
for use with this type of TV.
• Allowing the base of your TV to hang over any edge of this
speaker system increases the risk of the TV tipping, which may
result in injury.
• If your TV comes with an anti-tip device, install it according to the
manufacturer's instructions and adjust the tether as instructed
after placing the TV on top of the system. Installing an anti-tip
device is recommended when using a TV with this product. If
your TV did not come with an anti-tip device, you can get one
from most retail TV suppliers.
To avoid wireless interference:
• Keep other wireless equipment away from the system.
• Place the system outside of and away from metal cabinets, other
audio/video components and direct heat sources.

Sample system placement

8 - English

Turning off your TV speakers

To avoid hearing distorted sound, turn off your TV speakers.
Refer to your TV's owner's guide for more information.

Powering on the system

1. Power on your TV.
2. If you are using a cable/satellite box or other secondary
source, power on the source.
3. Press the Power button (
The status indicator glows green.
Status indicator
4.
Check if sound is coming from the system.
Note: If you do not hear sound coming from the system, see
"Troubleshooting" on page 18.

Confirming your TV speakers are off

1.
Press the Mute button ( ) on the remote.
2. Check that no sound is coming from your TV.
Note: If you hear sound coming from your TV, see
"Troubleshooting" on page 18.
) on the remote control.