H3C S9500 Series Operation Manual page 5

Operation Manual – IPv6 Static Routing
H3C S9500 Series Routing Switches
[SwitchB] ipv6 route-static 3:: 64 5::1
# Configure the default IPv6 static route on Switch C.
<SwitchC> system-view
[SwitchC] ipv6 route-static :: 0 5::2
3) Configure the IPv6 addresses of hosts and gateways.
Configure the IPv6 addresses of all the hosts based upon the network diagram,
configure the default gateway of Host A as 1::1, that of Host B as 2::1, and that of Host
C as 3::1.
4) Display configuration information
# Display the IPv6 routing table of Switch A.
[SwitchA] display ipv6 routing-table
Routing Table :
Destination
NextHop
Interface
Destination
NextHop
Interface
Destination
NextHop
Interface
Destination
NextHop
Interface
Destination
NextHop
Interface
# Verify the connectivity with the ping command.
[SwitchA] ping ipv6 3::1
PING 3::1 : 56
Reply from 3::1
bytes=56 Sequence=1 hop limit=254
Reply from 3::1
bytes=56 Sequence=2 hop limit=254
Destinations : 5
: ::/128
: FE80::510A:0:8D7:1
: Vlan-interface200
: ::1/128
: ::1
: InLoop0
: 1::/64
: 1::1
: Vlan-interface100
: 1::1/64
: ::1
: InLoop0
: FE80::/64
: ::
: NULL0
data bytes, press CTRL_C to break
Chapter 1 IPv6 Static Routing Configuration
Routes : 5
time = 63 ms
time = 62 ms
1-4
Protocol : Static
Preference : 60
Cost : 0
Protocol : Direct
Preference : 0
Cost : 0
Protocol : Direct
Preference : 0
Cost : 0
Protocol : Direct
Preference : 0
Cost : 0
Protocol : Direct
Preference : 0
Cost : 0