ZyXEL Communications GS-4012 User Manual page 369

Table 140 interface port-channel Commands (continued)
COMMAND
bpdu-control
<peer|tunnel|disc
ard|network>
broadcast-limit
dhcp snooping
trust
dhcp snooping
limit rate <pps>
diffserv
dlf-limit
egress set <port-
list>
ethernet oam
exit
flow-control
frame-type
<all|tagged|untag
ged>
GS-4012F/4024 User's Guide
DESCRIPTION
Sets the maximum bandwidth
egress <Kbps>
allowed for outgoing traffic on the
port(s).
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
Enables broadcast storm control
limit on the port(s).
Specifies the maximum number of
<pkt/s>
broadcast packets to allow
through the port.
Sets this port as a trusted DHCP
snooping port. Trusted ports are
connected to DHCP servers or
other switches, and the Switch
discards DHCP packets from
trusted ports only if the rate at
which DHCP packets arrive is too
high.
Sets the maximum rate that
DHCP packets are allowed to
arrive at a trusted DHCP snooping
port.
Enables DiffServ on the port(s).
Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in
<pkt/s>
packets per second (pps).
Sets the outgoing traffic port list
for a port-based VLAN.
Enables Ethernet OAM on the
port(s).
Specifies active or passive OAM
mode
mode on the ports. Active mode
<active|passive>
allows the port to issue remote
loopback and discovery
commands. Passive mode means
that the port can only respond to
Ethernet OAM commands.
Enable Ethernet OAM remote-
remote-loopback
loopback capability on the port(s).
supported
Exits from the interface port-
channel command mode.
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
Choose to accept both tagged
and untagged incoming frames,
just tagged incoming frames or
just untagged incoming frames on
a port.
Chapter 45 Introducing Commands
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
369