Monster SuperClean 60 Instruction Manual page 26

Fiberglass or Stainless Steel Surfaces
Use the floor brush or detail brush. Slowly move
the brush over the surface to be cleaned. The
steam will emulsify the dirt and grease on the
surface. Follow behind with a cotton cloth
over the brush to remove excess moisture and
residue.
Tip: An old idea for polishing stainless steel
is to wipe it down with soda water after it is
cleaned.
Soap Scum
Soap scum dissolves almost immediately under
a combination of heat and moisture. Afterwards
rinse the surface with a small amount of water
or go back over it once more with a clean
cotton cloth.
Note: Soap scum will sometimes develop a hard
surface from waterborne minerals. If this is the
case, use the floor brush with no cloth first to
break up this surface - or spray or wipe first with
lemon, vinegar or soda water to soften the mi-
nerals. Moving too slowly can dry out the soap
scum and cause it to granulate on the surface.
The surface will have a gritty feel. If this happens,
apply steam to the surface with the open brush
again and re-clean.
Bathroom Areas
To clean the bath or shower area, use the detail
brush for grout, shower door tracks, hard to get
areas and heavily soiled areas. The window
cleaner will be the most efficient way to clean
the rest of the tiled area.
Allow plenty of time for the heat to penetrate
the surface. This is especially helpful in the
shower area if there is tile or grout.
Removal of soap scum on tiles, grout, and
shower doors and fittings is also easier with the
Monster 60.
To clean sanitary fixtures, use the detail nozzle
with or without the detail brush. Use a terry cloth
towel or paper towel to wipe up excess moisture
and residue.
Use the detail brush to clean the sink and
taps.
Usage Suggestions (cont.)
Garden Furniture
Use either of the brushes depending on the
surface area.
Work quickly when cleaning resin outdoor furni-
ture.
Exterior Areas
To clean inside your car, use the floor brush with
the cotton cloth attached to clean upholstery
and interior areas just as in the home. You should
not expose the bristles to leather - use only the
brush with the cotton cloth attached. For de-
tailing the wheels, use the detail nozzle and the
detail brush. Exterior windows are cleaned best
by applying the steam with the detail nozzle and
wiping with a paper towel.
To clean bicycles, use the detail brush.
To clean equipment, use the detail brush, de-
pending on the surface area.
Artificial Plants
Use the detail nozzle without a brush attached
to blow off the dust and dirt.
Clothing
Your Monster 60 SuperClean is excellent for
removing wrinkles from fabrics. Simply steam
the surface from a distance. The dry steam
removes wrinkles without leaving the fabric wet
like ordinary fabric steamers do.
Nicotine and Tar
Nicotine and tar dissolves at high temperatures
and becomes a light yellow oil that has the
consistency of sewing machine oil. When the
nicotine/tar film is touched by a hot cotton cloth
clipped over the floor brush, it immediately dis-
solves and flows into the cloth. You can remove
it from flat surfaces as fast as you can move the
brush over the surface.
Removing Wax, Tar, Etc.
Many stains are only stuck on the surface of ma-
terials and can be easily and quickly removed
by "blowing" excess material away from the
surface from the side. This is accomplished by
using the detail nozzle.
Hold the cotton cloth to the side to catch the
loose residue as is blown by the nozzle.
Note: Always vacuum any loose residue off the
surface before you apply steam to it.
26