General; About This Document; Safety; Personnel Qualification - Dimplex UPH 120-32 PK Installation And Operating Instruction

English
1

General

1.1 About this document

The installation and operating instructions are part of the prod-
uct. They must always be available close to the product. These
instructions must be observed to ensure that the device is used
and operated as intended.
2

Safety

These operating instructions contain basic notes which must
be observed during installation and operation. It is therefore es-
sential for the technician and the operator to read these operat-
ing instructions before the product is installed and started up.

2.1 Personnel qualification

Any personnel involved in the installation must be qualified to
carry out this kind of work.

2.2 Danger in case of non-observance of the safety information

Persons and/or the pump/system are at risk if the safety notes
are not observed.

2.3 Safety notes for the operator

Observe the valid accident prevention regulations
It must be ensured that there are no risks resulting from electri-
cal energy. Instructions resulting from local or general regula-

2.4 Safety notes for inspection and installation work

The operator must ensure that all inspection and installation
work is carried out by authorised and qualified specialists who
have studied the operating instructions in detail.

2.5 Impermissible operating modes

The operating safety of the pump supplied can only be ensured
if the pump is properly used according to Cap. 4 on page 3 of
3

Transport and intermediate storage

CAUTION!
Danger of damage to the pump
Danger of damage due to improper handling during transport
and storage.
The pump must be protected against humidity, frost and
mechanical damage during transport and intermediate
storage.
EN-2
Not only the safety information listed here under Safety must
be observed, but also the special safety information listed
under the other sections and marked with safety notes.
tions (e.g. IEC, VDE etc.) and from local utility companies must
be observed.
Work on the pump/system must only be carried out when the
pump/system is not operating.
Unauthorised alterations and the manufacture of spare parts
are not permitted.
the operating instructions. The limit values stated in the cata-
logue/on the data sheet must never be undershot/exceeded.
452115.66.46 · FD 0004
UPH 120-32PK