Wps Station Screen; Scheduling; Figure 71 Wps Station; Table 38 Wps Station - ZyXEL Communications ZyXEL NBG420N User Manual

7.9.2 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second
wireless station, you have to press these buttons on both device and the
wireless station again after the first 2 minutes.

Figure 71 WPS Station

The following table describes the labels in this screen.

Table 38 WPS Station

LABEL
Push Button
Or input station's
PIN number

7.9.3 Scheduling

Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN
scheduling is disabled by default. The wireless LAN can be scheduled to turn on or off on
certain days and at certain times. To open this screen, click Network > Wireless LAN >
Scheduling tab.
NBG420N User's Guide
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration) method to
configure wireless stations's wireless settings. See
Click this to start WPS-aware wireless station scanning and the wireless security
information synchronization.
Use this button when you use the PIN Configuration method to configure wireless
station's wireless settings. See
Type the same PIN number generated in the wireless station's utility. Then click
Start to associate to each other and perform the wireless security information
synchronization.
Chapter 7 Wireless LAN
Section 6.1.2.1 on page
Section 6.1.2.2 on page 75.
74.
107