Accessories - Midea MFA-18HRDN1-Q Manual

3. ACCESSORIES

Please check whether the following fittings are of full scope. If there are some spare fittings , please restore them carefully.
Table 3-1
Installation fittings
Remote controller & Its Frame
Others
Cautions on remote controller installation:
Never throw or beat the controller.
Before installation, operate the remote controller to determine its location in a
reception range.
Keep the remote controller at least 1m apart from the nearest TV set or stereo
equipment. (it is necessary to prevent image disturbances or noise interferences.)
Do not install the remote controller in a place exposed to direct sunlight or close to a
heating source, such as a stove.
Note that the positive and negative poles are right positions when loading batteries.
This manual is subject to changes due to technological improvement without further
notices.
NAME
1.Hook
2. Remote controller
3. Frame
4. Mounting screw(ST2.9×10-C-H)
5. Alkaline dry batteries (AM4)
6. Installation & Owner's manual
7. Holding sponge
8. Wrapping tape
SHAPE QUANTITY
2
1
1
2
2
1
2
1
SET TEMPERATURE O C)
AUTO FAN
COOL HIGH
DRY MED
HEAT LOW
TEMP.
ON/OFF FAN SPEED
MODE
SWING ECONOMIC TIMER ON
RESET LOCK TIMER OFF
AIR DIRECTION POWERFUL
Remote
controller
Mounting screw B
ST2.9x10-C-H
Remote controller
holder
Fig.3-1
installation & owner's manual
3