Warning - Midea MFA-18HRDN1-Q Manual

Set the starting & stopping time
1. Push the TIMER ON button, the remote controller will
show TIMER ON, the last set time for START operation
and the signal "h" will be shown on the DIGITAL display
area. You are now ready to readjust the TIMER ON to start
the operation.
2. Push the TIMER ON button again to set the time you want
to start the operation.
3. Push the TIMER OFF button, the remote controller will
show TIMER OFF, the last set time for STOP operation
and the signal "h" will be shown on the DIGITAL display
area. You are now ready to reset the time to STOP
operation.
4. Push the TIMER OFF button again to set the time you want
to stop the operation.
5. After setting the TIMER, there will be a one-half second
delay before the remote controller transmits the signal to
the Air Conditioner. Then , after approximately another 2
seconds, the set temperature will re-appear on the digital
display .
Change the TIMER
To change the TIMER ON/OFF time, just press the correspo-
nding TIMER button and reset the time.
NOTE
The setting time is relative time. That is the time set is
based on the delay of the current time.

5. Warning

1. Be sure there are no obstacles between the remote
controller and the receiver of indoor unit otherwise the air
conditioner will not work.
2. Keep the Remote Controller away from any liquids.
3. Protect the remote controller from the high temperatures
and exposure to radiation.
4. Keep the indoor receiver out of direct sunlight or the Air
Conditioner may malfunction.
5. Keep Remote Controller away from EMI (Electro-Magnetic
Interference) supplied by other household appliances.
6. When replacing batteries, do not use old batteries or a
different type battery. This may cause the remote control
to malfunction.
7. If you do not use the remote controller for several
weeks remove the batteries. Otherwise battery leakage
may damage the remote controller.
8. The average battery life under normal use is about 6
months.
9. Replace the batteries when there is no answering beep
from the indoor unit or if the Transmission Indicator light
fails to light.
installation & owner's manual
19