Figure 5-7 Roaming; Table 5-2 Roaming - ZyXEL Communications Wireless Access Point ZyAIR B-500 User Manual

ZyAIR B-500 Wireless Access Point User's Guide
5. The access points must be connected to the Ethernet and be able to get IP addresses from a DHCP
server if using dynamic IP address assignment.
To enable roaming on your ZyAIR, click the WIRELESS link under ADVANCED and then the Roaming
tab. The screen appears as shown.
The following table describes the labels in this screen.
LABEL
Select Yes from the drop-down list box to enable roaming on the ZyAIR if you have two or
Active
more ZyAIRs on the same subnet.
All APs on the same subnet and the wireless stations must have the
Port Enter the port number to communicate roaming information between access points. The
port number must be the same on all access points. The default is 16290. Make sure this
port is not used by other services.
Apply Click Apply to save your changes back to the ZyAIR.
Reset Click Reset to begin configuring this screen afresh.
5-10

Figure 5-7 Roaming

Table 5-2 Roaming

DESCRIPTION
same ESSID to allow roaming.
Wireless Configuration and Roaming