Restore Configuration; Table 17-3 General Commands For Third Party Tftp Clients - ZyXEL Communications Wireless Access Point ZyAIR B-500 User Manual

where "i" specifies binary image transfer mode (use this mode when transferring binary files), "host" is the
ZyAIR IP address, "get" transfers the file source on the ZyAIR (rom-0 name of the configuration file on
the ZyAIR) to the file destination on the computer and renames it config.rom.
The following table describes some of the fields that you may see in third party TFTP clients.

Table 17-3 General Commands for Third Party TFTP Clients

COMMAND
Host
Send/Fetch
Local File
Remote File
Binary
Abort

17.3 Restore Configuration

Menu 24.6 –- System Maintenance – Restore Configuration allows you to restore the configuration via
FTP or TFTP to your ZyAIR. The preferred method is FTP. Note that this function erases the current
configuration before restoring the previous backup configuration; please do not attempt to restore unless
you have a backup configuration stored on disk. To restore configuration using FTP or TFTP is the same as
uploading the configuration file, please refer to the following sections on FTP and TFTP file transfer for
more details. The ZyAIR restarts automatically after the file transfer is complete.
Firmware and Configuraiton File Maintenance
Enter the IP address of the ZyAIR. 192.168.1.2 is the ZyAIR's default IP
address when shipped.
Use "Send" to upload the file to the ZyAIR and "Fetch" to back up the file on
your computer.
Enter the path and name of the firmware file (*.bin extension) or configuration
file (*.rom extension) on your computer.
This is the filename on the ZyAIR. The filename for the firmware is "ras" and for
the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
ZyAIR B-500 Wireless Access Point User's Guide
DESCRIPTION
17-5