Advertisement
INTRODUCTION
Prisma Light Constant
The simplest models
They light up when the power is turned ON at the given power
output that was installed in the factory.
If you want to make any changes to the power output you
will have to send the luminaire back to PrismaTibro.
Prisma Light DALI
With a DALI-driver it is possible to change the power output and
night reduction after the luminaire has been installed.
The adjustments can be made in different ways:
Alternative 1
Alternative 2
You go all the way up to the luminaire that is mounted
on the pole and you make the adjustments close to the driver.
You buy the luminaire with a 5-wired cable, then you
can make the adjusments down at the
access point in the pole.
prismatibro.se | Prisma Light
3
Advertisement
