Table of Contents
Advertisement
Pin Description
Pin No.
Symbol
1
VDD
2
GND
3
SCK
4
MISO/IO1
5
MOSI/IO0
6
/CS
7
/INT
8
/PD
9
AUDIO_L
10
N.C.
11
GPIO0/IO2
12
GPIO1/IO3
13
GPIO2
14
GPIO3
15 - 16
N.C.
17 - 18
VBL
19 - 20
GND
CN1: Male IDC Box Header - 20-Pin, 2x10, 2.54mm pitch.
CN2: FFC Connector - 20-Pin, 1.0mm pitch, Top-contact.
NOTICE: It is not recommended to apply power to the board without a display connected. Doing so may result in a
damaged LED driver circuit. Newhaven Display does not assume responsibility for failures due to this damage.
Controller Information
This EVE2 TFT Module is powered by the FTDI/Bridgetek FT813 Embedded Video Engine (EVE2).
To view the full FT81x specification, please download it by accessing the link below:
http://www.ftdichip.com/Support/Documents/DataSheets/ICs/DS_FT81x.pdf
Display Information
Part Number
NHD-7.0-800480EF-ATXL#-CTP
This product consists of the above TFT display assembled with a PCB which supports all the features of this module.
For more details on the TFT display itself, please download the specification at:
http://www.newhavendisplay.com/specs/NHD-7.0-800480EF-ATXL-CTP.pdf
Arduino Application
If using or prototyping this EVE2 TFT Module with the low-cost, widely popular Arduino platform we highly recommend
using our Arduino shield, the NHD-FT81x-SHIELD. Not only does the NHD-FT81x-SHIELD provide seamless connectivity
and direct software compatibility for the user, but it also comes with the following useful features on-board:
logic level shifters to allow the 5V Arduino to communicate with the 3.3V FT81x
regulators to allow the Arduino to output more current to the EVE2 TFT Module
audio filter/amplifier circuit to utilize the EVE2 TFT Module's audio output signal
microSD card slot, which allows expandable storage for data such as images, video, and audio to be stored.
Please visit the NHD-FT81x-SHIELD product webpage for more info.
External Connection
Function Description
Power Supply
Input Voltage for TFT and FT81x (3.3V)
Power Supply
Ground
MCU
SPI Clock (Input)
MCU
SPI MISO (Output) / Quad-SPI mode: SPI data line 1
MCU
SPI MOSI (Input) / Quad-SPI mode: SPI data line 0
MCU
SPI Chip Select (Input), Active LOW
MCU
Interrupt to host (Output), Active LOW
MCU
Power Down control (Input), Active LOW
Filter/Amplifier
Audio PWM out (Output)
-
No Connect
MCU
General Purpose IO0 / SPI Quad mode: SPI data line 2
MCU
General Purpose IO1 / SPI Quad mode: SPI data line 3
MCU
General Purpose IO2
MCU
General Purpose IO3
-
No Connect
Power Supply
Input Voltage for LED Backlight Driver (3.3V/5V)
Power Supply
Ground
Display Type
Standard
Luminance Rating
Viewing Angle
230 cd/m²
[5]
Interface
12:00
24-Bit RGB
Advertisement
Table of Contents
