Upnp Overview; Configuring Upnp - ZyXEL Communications Prestige 650H-E Series Manual

Table 8 Adding/Editing Source and Destination Addresses
LABEL
Address Type
Start IP Address
End IP Address
Subnet Mask

5.8 UPnP Overview

Universal Plug and Play (UPnP) is a distributed, open networking standard that uses TCP/IP for
simple peer-to-peer network connectivity between devices. A UPnP device can dynamically join a
network, obtain an IP address, convey its capabilities and learn about other devices on the network.
In turn, a device can leave a network smoothly and automatically when it is no longer in use.
All UPnP-enabled devices may communicate freely with each other without additional
configuration. Disable UPnP if this is not your intention.
Windows ME and Windows XP support UPnP. See the Microsoft website for information about
other Microsoft operating systems.
Make sure you apply Microsoft's UPnP security patch before enabling the

5.9 Configuring UPnP

Click Advanced Setup and then UPnP to open the UPnP screen.
Do you want your rule to apply to packets with a particular (single) IP address, a range of
IP addresses (e.g., 192.168.1.10 to 192.169.1.50), a subnet or any IP address? Select an
option from the drop down list box
Enter the single IP address or the starting IP address in a range here.
Enter the ending IP address in a range here.
Enter the subnet mask here, if applicable.
UPnP feature. Refer to the Microsoft website.
Prestige 650H-E
DESCRIPTION
Figure 23 UPnP
26