Siemens VZ46001 Instruction Manual page 24

en
Please fold out the picture page.
Set up
1
Figure
Attach the turbo upholstery nozzle to the hand grip
on the vacuum cleaner hose.
This is designed especially for thorough cleaning of
upholstered furniture, mattresses, etc.
!
Set the suction level to maximum when you are
using the brush.
Caution!
Floor tools are subject to a certain amount of wear,
depending on the type of hard floors you have
(e.g. rough, rustic tiles). Therefore, you must check
the underside of the floor tool at regular intervals.
Worn undersides of floor tools may have sharp edges
that can damage sensitive hard floors, such as parquet
or linoleum. The manufacturer does not accept any
responsibility for damage caused by worn floor tools.
Care
!
Always switch off the vacuum cleaner and remove
the plug from the socket before starting to clean it.
2
Figure
Remove the turbo upholstery nozzle from the hand
grip.
3
Figure
Cut through threads and hairs wound round the
rollers using scissors.
4
Figure
Vacuum threads and hairs with the crevice nozzle.
5
Figure
If it is very dirty or blocked, the nozzle can be
opened.
To do so, bring the sleeve to the middle position,
depress the locking button and slide the sleeve in
the direction of the arrow.
22
6
Figure
For easier cleaning, remove the driving wheel from
the nozzle.
7
Figure
Insert the wheel and close the cover.
Slide the sleeve back towards the front.
!
The holder for the drive shaft must sit correctly
before closing, otherwise the cover will not be able
to close.
Subject to technical modifications.