Daikin FXAQ-M Series Engineering Data page 27

Installation
(3) Remove the screw from the service lid and pull the handle forward.
(6) Point the pipe in the direction it will be passed out.
For bottom-right and back-right piping, refer to Figure 6.
• Wrap the drain hose and the refrigerant piping together with the
insulating tape (4) so that the drain hose is below the refrigerant
piping.
For left, bottom-left, and back-left piping, refer to Figure 7.
• Remove the front grille.
Remove the front grill as described below when securing the indoor unit
with screws or when attaching Optional Accessories (wireless remote
controller, adapter PC board, etc.).
(1) Remove the front panel.
(2) Remove the screws in the (2) positions in case of 12 type/3 places in case of 18, 24 type) securing the front grille.
(3) Remove the tabs in the (3) positions, securing the front grille by pushing them in the direction of the arrows.
(4) Making sure not to catch the horizontal flaps, remove the front grill by pulling in the direction of the arrow.
(3)
Screw position
(2)
• Remove the drain plug, the pipe insulation , and the drain hose from the drain pan, referring to
Figure 8.
• Connect the local refrigerant piping ahead of time, matching it to the liquid pipe and gas pipe marks engraved on
the installation panel (1) in Fig. 3.
< Replacing the drain hose and drain plug >
(1) Remove the drain plug and pipe insulation .
(2) Remove the drain hose and replace to the left side..
26
Axis
(2)
Axis
Tab position
(3) (3)
(2)
Screw position (In case of 18, 24 type)
Front panel
(1)
Axis
(2)
Fig. 5
Tab position
Front grill
(2)
Fig. 7
EDUS39-600-F6
Service lid
(3)
Handle
Screw
Insulating tape (4)
Refrigerant piping
Drain hose
Fig. 6
Tab
(4)
FXAQ-M