Quer KOM0480 Owner's Manual page 8

Owner's manual
II. Operating instructions
1. Remote control and receiver connection (Pa-
iring)
The remote control and receiver is default paired in factory. Just
need to plug the receiver into USB socket of the set-top box (com-
puter), the receiver can automatically connect to the remote con-
trol. Irregular connection and communication between the remo-
te and receiver, that caused by any operation error during using of
the remote, or other reasons, can be reconnected through the fol-
lowing methods:
Press [OK] and [BACK] keys for about 3 to 5 seconds. The ope-
ration indicating LED starts flashing. It indicates the remote enters
Code Matching Mode. Release both keys, and plug the USB rece-
iver to the USB socket of TV or Computer within 20 seconds. The
remote and device starts auto code matching. If LED turns off, it
means the code is successfully matched.
2. Air mouse travelling speed (sensitivity) adjust-
ment function (option)
The Air mouse sensitivity is divided into 4 gears. The greater the
value of air mouse is, the faster the speed (the higher sensitivity)
of air mouse will be. The default gear is gear 3.
• Speed up the air mouse speed: Press [OK] + [V+] for about 3 se-
conds. Indicating light flashes twice. The CPI increase 1 gear on
the basis of current speed.
• Slow down the air mouse speed: Press [OK] + [V-] for about 3 se-
conds. Indicating light flashes twice. The CPI decrease 1 gear on
EN
the basis of current speed.
Note: When the speed reaches the highest gear (gear 4), remote
control can no longer speed up. It can
only implement "slow down" operation.
8