Festool CXS Operating Manual page 12

GB
CXS
LED green - continuous
light
Battery pack is charged.
LED red - light flashes
General fault indicator, e.g.
incomplete contact, short cir-
cuit, defective battery pack,
etc.
LED red - continuous light
Battery temperature is outside
permissible limit values (0 °C
to 45 °C).
7 Settings
WARNING
Risk of injury
Always switch off the machine before ad-
justing settings!
7.1 Changing direction of rotation [1-
5]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rota-
tion
7.2 Changing gear [1-4]
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
7.3 Adjusting torque [1-1]
The arrow [1-3] aligns with the adjusted
state.
Drilling
Drilling symbol [1-2] on adjustment ring
aligns with the arrow = maximum torque..
Fastening
Torque corresponding to setting:
Position 1 = low torque
Position 12 = high torque
8 Tool holder, attachments
WARNING
Risk of injury, electric shock
Always disconnect the battery pack before
any type of work on the machine!
12
The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN-
TROTEC tool chucks.
Wear gloves when replacing!
8.2 Chuck BF-FX8 [5]
For clamping drill bits and bits with max. shaft
diameter of 8 mm.
Clamp tool centricly in the chuck.
8.3 Elbow adapter XS-AS [6]
(accessories) Drilling and screwdriving at right
angle to machine.
You can engage the elbow adapter in 16
different angle settings.
8.4 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.
9 Working with the machine
9.1 On/Off switch [1-6]
Press = ON, release = OFF
The speed of the machine depends on how
far the on/off switch is pressed in.
The LED bulb [1-10] lights up when the ON/
OFF switch is pressed [1-6].
9.2 Bit depot [1-9]
Magnetic, for storing bits and bit holders.
9.3 Warning signals [8]
Machine shuts down, light flashes twice:
Battery pack is empty.
Change the battery pack.
Machine shuts down, light does not flash:
Machine is overheated or has been overloaded.
Reduce the machine load.
Allow the machine to cool down.
10 Service and maintenance
Customer service and repair
only through manufacturer or ser-
vice workshops: Please find the
nearest address at:
www.festool.com/Service