ZyXEL Communications P-2602HWNLI Quick Start Manual page 4

80.11g wireless adsl2+ 4-port voip iad

Hide thumbs Also See for P-2602HWNLI:

Note: When the P-2602HWNLI does not have power, only the phone connected to the

PHONE 1 port can be used for making calls. Ensure you know which phone this is, so

that in case of emergency you can make outgoing calls.

ISDN PHONE: Use telephone wire to connect one or more ISDN telephones or an ISDN PBX to this port.

3 PSTN/ISDN: You can connect either a PSTN or an ISDN line to this port. This is a Foreign eXchange Office

(FXO) port. Use the included green PSTN cable or ISDN cable to connect the PSTN/ISDN port.

• Connect the PSTN line cable's larger end to the PSTN/ISDN port. Connect the other end to the tele-

phone jack or the TEL or PHONE socket on a splitter.

• The ISDN line cable's connectors are of equal size. Connect either end to the PSTN/ISDN port. Con-

nect the other end to an ISDN Terminal Adapter (TA). Connect the TA's other port to the telephone jack

or the TEL or PHONE socket on a splitter.

Note: If you are using T-ISDN (UR-2), connect the green wire to a TAE connector before connecting it

to the telephone splitter's "phone" jack or a telephone wall jack.

4 ETHERNET: Use an Ethernet cable to connect a computer to an Ethernet port for initial configuration and/

or Internet access.

5 POWER: Use the included power adaptor to connect the POWER socket to an appropriate power source

(see the User's Guide for details of power adaptors by region).

6 Push in the POWER button and look at the lights on either side.

• The POWER light blinks during start-up and stays on once the P-2602HWNLI is

ready.

• The DSL light blinks during start-up, and stays on once the P-2602HWNLI is

ready. If the DSL light is off, there is a problem with the hardware or the phone line

connection to the ISP.

• The ETHERNET lights blink once on startup, and remain on if there is an active

Ethernet connection. When the P-2602HWNLI is sending/receiving data on an

active Ethernet connection, the light blinks.

• The WLAN light turns steady green when the wireless LAN is ready. It blinks when

the P-2602HWNLI is sending/receiving data through the wireless LAN.

• Use the following sections in this guide to get to the screens where you configure

Internet access, wireless and VoIP settings.

P-2602HWNLI Quick Start Guide

Table of Contents