Advertisement
INSTRUCTION SHEET
Installation attachment: Drop wire or flange
(see sizing chart on page 1)
Part Number
6MB18
812MB18
16NB18
MCS50B18
MCS100B18
6M3B18CO
6MB186
812MB186
16MB186
1) Squeeze fastener and connect top edge
812MB188Z
over wire, rod or onto flange edge.
Twist into place and squeeze.
Installation attachment: Bottom mount flange
(see sizing chart on page 1)
Part Number
6MB1824
812MB1824
16MB1824
6MB1824
812MB1858
16MB1858
812MB18912
1) With Hammer, tap clamp
onto flange.
Installation attachment: Screw or threaded rod
(see sizing chart on page 1)
Part Number
6MB18A
812MB18A
16MB18A
MCS50B18A
6M3B18ACO
812MB18S
1) Insert threaded rod or screw through the center hole of the
box and B18 series hanger as shown.
Threaded rod needs a nut and washer placed against
the box and B18 series hanger to secure them.
When a screw or stud is used, a nut is only needed on
the side opposite of the screw head to secure the assembly.
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other trademarks
are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
TECHNICAL SUPPORT:
www.erico.pentair.com
FLANGE
2) Install conduit/cable in box.
CFS223_J
3 OF 4
2) Install conduit/cable in box.
Single swivel rotates 360
2) Install conduit/cable into the box.
© 1998-2017 Pentair All Rights Reserved
Advertisement
