Bell 882A200 Manual

BELLSYSTEM PRACTICES SECTION 503-200-110
AT&TCo Standard Issue 1, December 1975
882A200 TELEPHONE SETS
1. GENERAL mounting cord or the 225A adapter furnished with
each telephone set.
1.01 This section provides identification, installation,
and connection information for the 882A200 1.04 The 882A200 telephone set is available in
DESIGN LINE* telephone (Coquette)set (Fig. 1). white (-58) only.
*Trademark of AT&T Co. 2. IDENTIFICATION
1.02 Whenever this section is reissued, the reason 2.01 The 882A200 rotary dial equipped set is a
will be listed in this paragraph, new DESIGN LINE telephone set being
made available to the customer. The customer
Warning: Telephone apparatus or wiring buys the housing and handset from the telephone
shah not be installed in a location where company and the telephone company retains
minimum separation from other wiring ownership of the transmission and signaling
cannot be maintainedasspecit_edin Section components (Fig. 2 and 3).
460-300-149.
Fig. 1m882A200 DESIGN LINE Telephone Set
1.03
The customer's premises must be properly
wired with an appropriate connecting block
or jack in order to accept the D4BU-29 plug ended
Fig. 2mCustomer-Owned Components
NOTICE
Not for use or disclosure outside the
Bell System except under written agreement
Printed in U.S.A. Page 1