Bell 881B109 Manual

BELLSYSTEM PRACTICES SECTION 503-200-111
AT &TCo Standard Issue 1, March 1977
TELEPHONE SETS
881B109 AND 2881B109
1. GENERAL
1.01 This section provides identification, installation,
and connection information for the 881B109
(Fig. 1) and 2881B109 DESIGN LINE* telephone
+
(The Mickey Mouse + Phone**) sets.
*Trademark AT&TCo.
**Housing produced by American Telecommunication
Corporation.
©Walt Disney Productions. _:
Warning: Telephone apparatus or
wirinK shall not be installed in a
location where minimum separation
from other wirin K, as specified in ,+
Section 460-300-149, cannot be .....
maintained.
1.02 Whenever this section is reissued the reason
for reissue will be listed in this paragraph.
1.03 The customer's premises must be properly
wired with an appropriate connecting block
or jack in order to accept the D4BU-29 plug-ended
mounting cord or 225A adapter furnished with each
telephone set.
Fig. 1--881B109 DESIGN LINE Telephone Set
2. IDENTIFICATION
2.03 These telephone sets are intended to be
2.01 The 881B109 (rotary dial) and 2881B109 used as single line or two-party desk sets
(TOUCH-TONE + dial) equipped telephone and are not recommended for use on four- and
sets are new DESIGN LINE telephone sets being eight-party service.
made available to the customer. The customer
buys the housing and handset from the telephone
company and the telephone company retains
3. INSTALLATIONAND CONNECTIONS
ownership of the transmission and signaling
components. 3.01 These telephone sets are furnished from
the factory fully assembled and wired for
2.02 Refer to Table A for available codes and bridged ringing. To connect the telephone set,
ordering information, plug the mounting cord into a 625A jack or if the
NOTICE
Not for use or disclosure outside the
Bell System except under written agreement
Printed in U.S.A. Page 1