PotteryBarn Oval Lattice Recessed Medicine Cabinet Manual

Note: Professional installation required

• This hanging system is meant for drywall/stud mounting only.
• If walls are concrete, brick or plaster, please consult your local hardware store for assistance.
• For safety, installation by two people is recommended.

Tool Required (Not Included):

Stud Finder Phillips Screwdriver

Parts Included:

Wooden Cabinet (1pc) - A
:

Hardware Included

Shelf pin (12pcs) -a

Pre-Assembly:

Remove all parts and hardware from the box and lay out on a clear workspace, along with any plastic protective
•
packaging. Do not dispose of any contents until assembly is complete to avoid accidentally discarding small parts or
hardware.
Use the parts and hardware lists above to identify and separate each of the pieces included.
•
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
•

MOUNT CABINET TO THE WALL

Professional Mounting Instructions: See Figure 1
1. Mark the desired location on the wall for installation.
2. After verifying the recessed portion dimensions of cabinet, use appropriate tools to cut a rectangle in the wall
covering (sheetrock) measuring approximately 19.5 inches wide and 30 inches high. Use the level to make sure that the
cutout is true and level.
Note to the professional installer: Once the sheetrock cutout is removed, it is likely that at least one wall stud will interfere
with the inserted portion of this cabinet (A) and that some internal framing will be required. This will likely include cutting
a section from the interfering stud and adding stud sections to ensure that there is wood support located adjacent each
side of this cabinet (A) when it is inserted.
Oval Lattice Recessed Medicine Cabinet
Pencil
Glass Shelf (3pcs) -B
Rubber Pad (2pcs) – b
Page 1 of 3
Toggle Screw (4pcs) -c