Hilti TE 700-AVR Original Operating Instructions page 20

5 Fitting the side handle 2
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
▶ Fit the side handle.
5.1 Fitting / removing the accessory tool
WARNING
Risk of injury! The accessory tool gets hot during use and may also have sharp edges.
▶ Wear protective gloves when changing the tool.
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
Note
Check the accessory tool for damage or uneven wear each time before use and replace it if necessary.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage to
the product.
▶ Fit the accessory tool or, respectively, remove it.
5.2 Chisel positioning
Note
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
▶ Set the function selector switch to "Chisel positioning"
5.3 Locking the chisel
▶ Set the function selector switch to the "Chiseling" position
5.4 Chiseling 5
▶ Set the function selector switch to the "Chiseling" position
5.5 Setting the chiseling power
Note
Chiseling power can be reduced to approx. 70% by pressing the power level selector switch. The
power level LED then lights up, indicating reduced power.
Chiseling power can be adjusted only when the power tool is switched on and ready for use. To
reselect full chiseling power, press the chiseling power level selector switch again. Switching off and
then on again also causes the power tool to return to full chiseling power.
▶ Press the power level selector switch.
16
3
4
and position the chisel. .
and rotate the chisel until it engages.
.