Operation - Gardena 4040 Operating Instructions Manual

1276-27.960.02_30.09.2004.qxd

5. Operation

Setting the time and day
of the week :
1.
2.
3.
4.
5.
Setting the
watering programs :
1.
01.10.2004 09:35
Time and Day of the Week
You must set the current time and day of the week before you
can set the watering programs.
Valves which are already open are closed automatically after
one minute if the time is changed.
1. Plug in the power supply unit (without battery) or hold down
Reset key for 5 seconds.
T T I I M M E E and 2 2 4 4 H H flash in the display.
2. Set 24 or 12 hour display with the
the OK key.
T T I I M M E E and the hours (e.g.
3. Set the hour for the time using the
and confirm your entry by pressing the OK key.
T T I I M M E E and the minutes flash on the display.
4. Set the minutes for the time using the
tes) and confirm your entry by pressing the OK key.
T T I I M M E E and the day of the week flash on the display.
5. Set the day of the week using the
and confirm your entry by pressing the OK key.
The time and the day of the week have been set.
Watering Programs
Prerequisite : you must set the current time and day of the
week before you can set the watering programs.
To give you a better overview of your irrigation system and to make
it easier to enter the watering data, we recommend entering the
data for your valves on the watering plan included in the appendix
of these operating instructions. A maximum of 6 channels can be
open at the same time.
You can save 4 watering programs for each channel (a maxi-
mum of 4 programs x 12 channels = 48 programs).
If programs overlap, the channel status display will flash.
v Make sure no programs overlap.
Selecting the Channel and Program Memory Location :
1. Press the Channel key for the relevant channel (e.g. Channel 2).
Channels (e.g. 2 ) appears in the display and program 1 flashes.
Seite 17
- keys and confirm with
0 0 ) flash on the display.
- keys (e.g.
- keys (e.g.
- keys (e.g. FR Friday)
1 1 2 2
hours)
3 3 0 0
minu-
17