Advertisement
Fluid Management
AT1500 Canister Replacement
PRODUCT(S)
AT1500
PURPOSE
This instruction is for all customers using Fluid Management's ColorPro 4.x. software.
Follow this procedure if the pump or agitation motor has failed or the canister is
malfunctioning.
INSTRUCTIONS
1. Unplug dispenser power cord from outlet on rear of machine
2. Locate the closest access panel to the canister requiring replacement
3. Remove the mounting screws
4. Place the access panel to the side and out of the way
5. Locate the canister and pump assembly to be replaced
6. Disconnect the 3 different wire harness connectors plugged to the DVX pump and
agitation motor
a. Caution: do not pull on the wires; instead, pull on the plastic connector
housing. Use pliers or a flat head screw to remove connector B
7. Remove the quick disconnect fitting from the DVX pump nipple
a.
To remove the fitting, compress the inner collet towards the fitting. While
holding the collet inward, pull on the connector to remove it from the pump
b. NOTE: the tubing has colorant and it will drain. Prepare a container to catch
the colorant
8. Open the top lid and remove defective canister assembly
9. Push up on the base of the canister to remove canister
CTB-11
Reformatted document, re-released.
Technical Support
AT1500 Canister
Replacement
6/20/19
Original Release
Advertisement
Table of Contents
Related Manuals for Idex Fluid Management AT1500
Summary of Contents for Idex Fluid Management AT1500
- Page 1 Fluid Management Technical Support AT1500 Canister Replacement PRODUCT(S) AT1500 PURPOSE This instruction is for all customers using Fluid Management’s ColorPro 4.x. software. Follow this procedure if the pump or agitation motor has failed or the canister is malfunctioning. INSTRUCTIONS 1. Unplug dispenser power cord from outlet on rear of machine 2.
- Page 2 a. NOTE: be careful not to snag the pump and agitator motor harnesses when removing the canister 10. Write down the Home Offset position number on the new canister assembly DVX pump 11. Place new canister into open slot a. NOTE: when sliding new canister and DVX pump assembly into open slot, make sure that the harnesses do not get caught on the frame 12.
Need help?
Do you have a question about the Fluid Management AT1500 and is the answer not in the manual?
Questions and answers