Configuring A Server Behind Nat; Figure 149 Menu 15.2 Nat Server Setup; Table 93 Menu 15.1.1.1 Editing/Configuring An Individual Rule In A Set - ZyXEL Communications P-660H-T Series User Manual

The following table explains the fields in this menu.
Menu 15.1.1.1 Editing/Configuring an Individual Rule in a Set
Table 93
FIELD
Type
Local IP
Start
End
Global IP
Start
End
Server
Mapping Set
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

27.4 Configuring a Server behind NAT

Follow these steps to configure a server behind NAT:
1 Enter 15 in the main menu to go to Menu 15 - NAT Setup.
2 Enter 2 to display Menu 15.2 - NAT Server Sets as shown next.

Figure 149 Menu 15.2 NAT Server Setup

3 Enter 1 to go to Menu 15.2.1 NAT Server Setup as follows.
Chapter 27 Network Address Translation (NAT)
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select from a total of five types. These are
the mapping types discussed in the web configurator NAT chapter. Server allows you
to specify multiple servers of different types behind NAT to this computer.
Only local IP fields are N/A for server; Global IP fields MUST be set for Server.
This is the starting local IP address (ILA).
This is the ending local IP address (ILA). If the rule is for all local IPs, then put the Start
IP as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for One-to-One and
Server types.
This is the starting inside global IP address (IGA). If you have a dynamic IP, enter
0.0.0.0 as the Global IP Start. Note that Global IP Start can be set to 0.0.0.0 only if
the types are Many-to-One or Server.
This is the ending inside global IP address (IGA). This field is N/A for One-to-One,
Many-to-One and Server types.
Only available when Type is set to Server. Type a number from 1 to 10 to choose a
server set from menu 15.2.
" to save your configuration, or press [ESC] at any time to cancel.
Menu 15.2 - NAT Server Sets
1. Server Set 1 (Used for SUA Only)
2. Server Set 2
3. Server Set 3
4. Server Set 4
5. Server Set 5
6. Server Set 6
7. Server Set 7
8. Server Set 8
9. Server Set 9
10. Server Set 10
Enter Set Number to Edit:
P-660H/HW-T Series User' Guide
Press ENTER to Confirm
260