Amcor SF12000E-V2 User Manual page 5

•
Always place the unit on a dry and stable surface.
•
The appliance should not be installed in laundry or wet rooms.
•
The appliance must be placed in a room without sources of ignition (for
example:
open flames, an operating gas appliance or an operating electric heater).
•
R290 refrigerant gas complies with European environmental directives.
•
R290 has a low GWP (Global Warming Potential) of 3.
•
The air conditioner contains about 195 g of R290 refrigerant gas.
•
Do not use or store in an unventilated space with an area smaller than 10 m
per unit. The room must be such as to prevent stagnation of possible leaks of
refrigerant gas as there could be a danger of fire or explosion hazard should the
refrigerant come into contact with electric heaters, stoves or other sources of
ignition.
•
If the appliance is installed, used or stored in an unventilated room, the room
must be such as to prevent stagnation of possible leaks of refrigerant gas as
there could be a danger of fire or explosion should the refrigerant come into
contact with electric heaters, stoves or other sources of ignition.
•
Refrigerant gas may be odourless.
•
Do not use the product and contact the retailer for advice, if damage has
occurred to the unit which may have compromised the refrigerant system.
•
Any repairs or maintenance must only be carried out on the unit by a suitably
qualified engineer. Before opening and servicing the unit the authorized
engineer must be in possession of a copy of the manufacturer's service manual
and must follow the safety information contained within it to ensure all hazards
are minimized.
•
The refrigerant system should not be perforated or punctured.
Energy Saving and Unit Safety Protection Tips
•
Do not cover or restrict the airflow from the outlet or inlet grills.
•
For maximum performance the minimum distance from a wall or objects should
be 50cm.
•
Keep the filters clean. Under normal conditions, filters should only need
cleaning once every three weeks (approximately). Since the filters remove
airborne particles, more frequent cleaning maybe necessary, depending on the
air quality.
•
For the initial start up set the fan speed to maximum and the thermostat to 45
degrees lower than the current temperature. After, set the fan switch to low and
set the thermostat to your desired setting.
•
To protect the unit we recommend not using the cooling function when the
ambient temperature is higher than 35
o
C.
5
2