ZyXEL Communications P-660HW-Dx v2 Quick Start Manual page 11

• Click the wizard icon (
access the Internet.
If you still cannot access the Internet, take the following steps:
• If you are using Bridge mode (check Mode in the Network > WAN > Internet Connection screen) click
NAT > General and ensure Active Network Address Translation (NAT) is not selected. Click LAN >
DHCP Setup and ensure that DHCP is set to None. Your ISP gives your computer an IP address
directly. If you want to access the P-660HW-Dx v2 again, you need to use a static IP address in the
same subnet as your P-660HW-Dx v2 (the P-660HW-Dx v2's default IP address is http://192.168.1.1).
• Click the wizard icon (
access the Internet.
If you still cannot access the Internet, contact your Internet Service Provider.
3 If you cannot access the Internet using the wireless network, follow these steps.
A) On a computer in the wireless network, open your browser, and go to http://192.168.1.1. If you see the
login screen in section 3, follow suggestions
B) On a computer connected to the P-660HW-Dx v2, make sure your P-660HW-Dx v2 and the computers
on your wireless network are using the same wireless and wireless security settings. See the chapter on
Wireless LAN in the User's Guide for more information.
Viewing Your Product's Certifications
1 Go to www.zyxel.com.
2 Select your product from the drop-down list box on the ZyXEL home page to go to that product's page.
3 Select the certification you wish to view from this page.
P-660HW-Dx v2 Quick Start Guide
). Run the Internet/Wireless Setup wizard again. Check whether you can
). Run the Internet/Wireless Setup wizard again. Check whether you can
A - F
11
above. If you do not, go to the next step.