Page 1
LG-7000 Digital TENS Unit INSTRUCTION MANUAL INSTRUCTION MANUAL Distributed by: LGMedSupply.com PO Box 913 Cherry Hill, NJ 08003 FDA 510K www.lgmedsupply.com V1.0...
therapy, and the type of pain. In many patients, the reduction or Chapter 1 : INTRODUCTION elimination of pain lasts longer than the actual period of stimulation (sometimes as much as three to four times longer). In others, pain is EXPLANATION OF PAIN only modified while stimulation actually occurs.
2. TENS devices have no curative value. 3. TENS is a symptomatic treatment and as such suppresses the The LG-7000 Digital TENS Unit is a battery operated pulse generator sensation of pain, which would otherwise serve as a protective mechanism.
Chapter 7 : CONSTRUCTION BACK SIDE BACK BATTERY STRIP (10) BATTERY CASE (11) BELT CLIP FRONT (1) LEAD CONNECTOR SIDE (2) INTENSITY CONTROL (ON/OFF SWITCH) (12) PROTECTIVE COVER (3) PANEL COVER (4) LIQUID CRYSTAL DISPLAY (5) MODE CONTROL (6) SET CONTROL (7) INCREMENT CONTROL (8) DECREMENT CONTROL...
Chapter 8 : TECHNICAL SPECIFICATIONS pulse width in 40% range. The intensity is always increasing while the pulse width is The technical specification details of LG-7000 Digital TENS Unit are decreasing and vice versa. The intensity is as follows: decreased by 40% while the pulse width is...
The waveforms of the 5 stimulation modes are as follows. 1. Burst Chapter 9 : REPLACEABLE PARTS The replaceable parts and accessories of LG-7000 Digital TENS Unit devices are as given below – Except leads, electrodes, battery and battery case cover, please do not try o replace the other parts of a device 2.
5) Slowly turn on the LG-7000 Digital TENS Unit by rotating the I II. LABEL ntensity control (ON/OFF Switch) knobs. 6) Select the mode and settings as directed by your physician. The label attached to the back of 7) Slowly increase or decrease the intensity as directed by your...
TREATMENT MODE Chapter 14 : ATTACHMENT OF ELECTRODE Normal or Conventional TENS offers the practitioners complete con- LEAD WIRES trol over all the various treatment parameters of the instrument. The wires provided with the system insert into the jack sockets Burst Mode is analogous to the Low Rate TENS technique except the located on top of the device.
Replacement electrodes pain site. should be re-ordered through LGMedSupply.com (888-633-7360) to ensure proper quality. Follow application procedures outlined in Chapter 18: TIPS FOR SKIN CARE electrode packing, to maintain optimal stimulation and to prevent skin irritation.
Chapter 19 : APPLICATION OF RE-USABLE SELF Important ADHESIVE ELECTRODES 1. Do not apply to broken skin. 2. The electrodes should be discarded and re-ordered from your physician when they are no longer adhering. Application 3. The electrodes are intended for single patient use only. 1.
Page 12
To reduce the current strength or switch the device off, turn the 6. Increment Control control counter clockwise to the required setting or off-position, This button controls the increase of settings. When pressing respectively. this button, the parameter will increase. The controls are protected by a cap to avoid unintentional change of intensity.
Page 13
c. Set Pulse Width 11. Patient Compliance Meter Pulse Width is adjustable from 50 uS to 300 uS. Press “SET” This unit can store 60 sets of operation records. Total treatment control to enter this menu, then press “Increment” or “Decre- time up to 999 hours can be stored.
(c) Do not short the terminals of the battery. This will cause the Chapter 21: BATTERY INFORMATION battery to get hot and can cause permanent damage. Avoid storing the batteries in your pocket or purse where the termi- PRECATIONS nals may accidentally come into contact with coins, keys or any metal objects.
STANDARDS For safety reasons, review the following checklist before using your LG-7000 Digital TENS Unit. The LG-7000 Digital TENS Unit devices are in compliance with the EN 60601-1-2:2001 and EN 60601-1:1990+A1:1993+A2:1995+A13: 1. Check the device for external damage. 1996 safety standards.
Need help?
Do you have a question about the LG-7000 and is the answer not in the manual?
Questions and answers