Operation; Technical Specifications - Verilux CleanWave VH03 Manual

Operating your Verilux
1. Open battery compartment located on the underside of the handle area
2. Insert 4-AA alkaline batteries as indicated in battery cavity (batteries are not
included)
3. Carefully replace cover making sure to slide it completely closed
4. While holding Wand with bulb facing down and away from skin or eyes, press
the large blue button for 3 seconds (green light will fl ash). Press the blue
button again to activate the UV-C light source (green light will glow and stop
fl ashing)
5. Hold the Wand as close as possible over the area to be sanitized and slowly
move the Wand over the entire area
6. To turn the Wand off, press the blue button until the green light goes out
Note: A safety switch will automatically turn off the wand if the light source
is turned upward (it will go back on when the light source is once again
lowered).
Environment
Operating Temperature: 15°C to 35°C (59°F to 95°F)
Storage Temperature: 0°C to 40°C (32°F to 104°F)
Relative Humidity: 5% to 95% non-condensing
UV-C Bulb
0.6 WATT UV-C bulb; non-replaceable
Battery
4 standard AA batteries
Warning: This product contains a chemical known to the state of California to
cause birth defects or other reproductive harm.
VH03-MAN-Rev8.indd 5 VH03-MAN-Rev8.indd 5
Job#: 0.0672
Date: 08/28/09

Operation

® ®
CleanWave UV-C Sanitizing Travel Wand
Technical Specifi cations
5
Title: VH03 Manual
Version: VH03-MAN-Rev8
8/28/09 3:27 PM 8/28/09 3:27 PM