Advertisement
Quick Links
x2
This building should be
erected by two people.
Drill
2mm bit
For ease of assembly, it is
advisable to pilot drill all
screw holes and ensure all
screw heads are countersunk.
WINTER = HIGH MOISTURE = EXPANSION
SUMMER = LOW MOISTURE = CONTRACTION
PLEASE READ INSTRUCTIONS CAREFULLY.
For Assistance Please Contact Customer Care on
Before you start...
All buildings including the underside of the floor must be treated with a good quality waterproof
preservative or treatment prior to or during assembly, and retreated annually.
Preservative/treatments are available in a choice of colours and is left to the customers preference.
NATURAL MOVEMENT OF TIMBER THROUGHOUT THE SEASON
Timber is a natural material and will, during the year pick up moisture in damp periods and dry out during hot spells. There will be constant expansion
and contraction of the timbers which will be particularly noticeable during the dry periods as the boards will shrink, this is why all buildings have
slight tolerances built into them.
BUILDING A BASE
When thinking about where the building and base is going to be constructed: Ensure that there will be access to all sides for maintenance work and
annual treatment.
TYPES OF BASE
- Concrete 75mm laid on top of 75mm hard-core.
- Slabs laid on 50mm of sharp sand.
Whilst all products manufactured at Walton Garden Buildings Limited are made to the highest standards of Safety and in the case of
childrens products independently tested to EN71 level, Walton Garden Buildings Limited cannot accept responsibility for your safety whilst
erecting or using this product.
For domestic and family use only
Retain Instructions for future reference
Dimensions
Depth = 2223mm
Width = 2802mm
Height = 1984mm
0800 0142 333
Door Panel
Window Panel
Plain Panel
Rear Panel Right
Rear Panel Left
Strip
1x Door Strip- 60 x 1680mm
1x Door Strip- 45 x 1680mm
2x Front Cover Trim- 45 x1900mm
2x Side Cover Trim- 30 x1900mm
Fascia
1x Front Fascia- 60 x 1213mm
2x Side Fascia- 60 x 1202mm
2x Rear Fascia- 60 x 2050mm
Framing
1x Rear Panel Framing- 32 x 1806mm
3x Roof Support block- 45 x 210mm
1x Large Roof Support bar- 70 x 2650mm
1x Back Roof Support bar- 70 x 1303mm
1x Front Roof Support bar- 70 x 748mm
1x Rear roof framing- 32 x 2018mm
1x Rear roof framing- 32 x 2049mm
1x Front roof framing- 32 x 1196mm
2x Side roof framing- 32 x 1149mm
Floor
Roof
2x Door block- 32 x 140mm
Advertisement
Related Manuals for Walton 7x7 Corner shed
Summary of Contents for Walton 7x7 Corner shed
- Page 1 1x Front roof framing- 32 x 1196mm 2x Door block- 32 x 140mm Whilst all products manufactured at Walton Garden Buildings Limited are made to the highest standards of Safety and in the case of 2x Side roof framing- 32 x 1149mm childrens products independently tested to EN71 level, Walton Garden Buildings Limited cannot accept responsibility for your safety whilst erecting or using this product.
- Page 2 30mm Black Screw Step 3 3x Turn Key 30mm Screw 5x L’ Bracket Fix the corner with 3x 50mm Screw 50mm screw a shown in diagram. 40mm screws Do not secure the building 60mm Screw to the floor until the roof is fitted.
- Page 3 Step 7 Step 5 First position the Large Roof Roof support must be Before erecting the door panel level with top of framing support bar in the centre of the it is recommended to fit both building between the left and doors using the 2x T hinge per right corner.
- Page 4 Step 8 Step 10 First position the Front Roof Place the roof section on top of support bar in the centre of builidng, ensure roof framing the building between the front slots over each side. of the building and the large roof support bar.
- Page 5 Step 12 Fix the cover trims as shown using 3x 40mm screws per 30 x 1900mm strip. 45 x 1900mm 12x40mm screws Step 13 Fit the fascias to the building over the felt and secure in place with 40mm screws as shown. Pre drill to avoid splitting.