Advertisement
Step 5
Before erecting the door panel
it is recommended to fit both
doors using the 2x T hinge per
door.
Fix hinges to the doors with
30mm screws ensuring the
screws are located into the door
framing.
Position each door on to the
building leaving enough gap in
between doors and building. Fix
the door to the building with
30mm screws.
Fix door block and turn key to
top and bottom rear of right
door , using 40mm screws and
black 30mm screw for the turn
key.
fix the following strips to the
front of the doors using 3x
40mm screws per strip into the
rear framing
45 x1600mm to the left door
60 x 1600mm to the right door
Then attach the remaining turn
key to the left door using 1x
30mm black screw in line with
the back framing.
Step 6
c
Erect the door panel into
positon and fix to each panel
using 6 x 60mm screws as
shown in method c
Use 2 x 50mm screws to fix
panell to floor.
30mm
screws
28x30mm screws
6x40mm screws
3x30mm black screws
c
c
c
c
c
c
6 x60mm screws
2x50mm screws
Step 7
First position the Large Roof
support bar in the centre of the
building between the left and
right corner. Ensure the top face
of the support is level with the
top of the building and then
mark position below the
framing for the fittings.
Using the marked position, align
the roof support block and fix
2x100mm screws
using 2x100mm screws
diagonaly through the block. Do
this on both sides.
Roof support must be
level with top of framing
4x100mm screws
Advertisement
