Walton Sussex Summerhouse Building Contents

x2
Sussex Summerhouse
This building should be
erected by two people.
Drill
2mm bit
For ease of assembly, it is
advisable to pilot drill all
screw holes and ensure all
screw heads are countersunk.
Your instructions should be read carefully before commencing assembly.
Dispose of all packaging and plastic bags safely. Retain instructions for
safety advice for future reference. Note: plastic bags can be harmful to small children.
WINTER = HIGH MOISTURE = EXPANSION
SUMMER = LOW MOISTURE = CONTRACTION
Before you start
- Tools required for installation (Not Supplied)
- Drill & 2mm drill bit, Hammer, Spirit level, Measuring tape, Screwdriver (Phillips),
Stanley knife, Wood Saw & Step Ladder
- Check the pack and make sure you have all the parts listed.
- When you are ready to start, make sure you have the right tools at hand,
plenty of space and a clean dry area for assembly.
CARE & USE
WOOD TREATMENT All buildings will need treating with a good quality preservative /
treatment prior to or during assembly and retreated annually. Preservative / treatments
are available in a choice of colours and is left to the customers preference.
Varnish is not recommended.
NATURAL MOVEMENT OF TIMBER THROUGHOUT THE SEASON Timber is a natural
material and will, during the year pick up moisture in damp periods and dry out
during hot spells. There will be constant expansion and contraction of the timbers
which will be particularly noticeable during the dry periods as the boards will shrink,
this is why all buildings have slight tolerances built into them.
BUILDING A BASE
When thinking about where the building and base is going to be constructed:
Ensure that there will be access to all sides for maintenance work and annual treatment.
TYPES OF BASE
Concrete 75mm laid on top of 75mm hard-core.
Slabs laid on 50mm of sharp sand.
round. The base should be slightly smaller than the external measurement of the building, i.e. the cladding should overlap the base, creating a
Base Required
(12'x8') 3725mm
(10'x8') 3125mm
(8'x8') 2510mm
Specification
Height x Width x Depth
2330mm x 2413mm x 3725mm (12'x8')
2330mm x 2413mm x 3125mm (10'x8')
2330mm x 2413mm x 2510mm (8'x8')
For Assistance Please
Contact Customer Care on :-
01636 880514
If any parts have been
damaged during the assembly of
the building, replacement parts
can be ordered through our
customer care centre and will
carry a minimum charge.
Call Customer Care on :-
01636 880514
BUILDING CONTENTS
03WES0808DG
03WES0808PG
03WES0808PS 03WES1008PS
03WES1008WS
03WES0808WS
03WES0808F 03WES1008F
03WES0808R
03WES1008R
12x8 Roof Support
2918
10x8 Roof Support
2315
Door Beading
1703
Corner strips
1680
Door Head Beading
1207
Side WIndow Beading
692
1705
Veranda Upright
Fascia
03WES0808VR
Veranda Rail
Door
03WES1208PS
435
03WES1208WS
03WES1208F
Veranda Floor
03WES1208R
03WES0808V
Side WIndow beading
500
Front Glazing Beading
415
375
Tower Bolt Mount
140
373
Support Bar Block
10&12 models only
655
800
Glazed
Side Window
Fornt Gable
Glazing
Door Block
Door Strip