Total Module - Zoom 8080 Operation Manual

TOTAL Module

Strictly speaking, this module is not an effect module, but it serves for setting various parameters for the CONTROL
pedals and CONTROL switches. It also contains settings for the seamless function, for editing patch names and for other
parameters that affect all patches. The module has five pages which are switched with the UTILITY/PAGE key.
Page 1: Serial connection/parallel connection
Determines whether the EFF2 and EFF3 modules are connected in series or parallel.
PAGE 1
SERIAL/PARALLEL:
1
Serial connection
Page 2: CONTROL pedal and CONTROL switch settings
PAGE 2
CONTROL SET: CSW=
w
2 CP1=
MIN MAX 1 2 MIN
3 4
w
MIN MAX MIN
"VOL" is not the volume of a specific patch but the overall volume.
NO
In principle, the CONTROL switches cannot be used to control the same effect module as CONTROL pedal 1 or CONTROL pedal 2. If several
NO
controllers are set to the same module on this page, priority will be assigned in the order CP1, CP2, CSW when returning to the Play mode.
Only the controller with the highest priority is active and the others are set to "OFF" (
However, if the "CSW" parameter in the RTM page of the DLY module is set to a different item than the "RTM" parameter, the DLY module
can be assigned to CONTROL pedal 1 or 2 and the CONTROL switches at the same time. (
Page 3: Seamless function settings
The seamless function lets the reverb or delay sound from the previous effect linger on when you switch effects, creating a
smooth transition without audible breaks.
PAGE 3
SEAMLESS FUNCTION:
q
3 TIM=
MIN MAX 1 2 MIN
3 4
q
MIN MAX MIN
For reverb, the seamless function operates only if reverb in the newly selected module is off. If the programmed reverb time of the
NO
patch is shorter than the time set with the "TIM" parameter, the programmed reverb time has priority.
EF2 å EF3
Pressing the TYPE - key selects serial connection. " " appears on the display.
Pressing the TYPE + key selects parallel connection. " " appears on the display.
Parameters
q CSW (Control Switch) Sets the CONTROL switch module function. OFF, CMP, EF1,
q
e
CP2=
w CP1 (Control Pedal 1) Sets the CONTROL pedal 1 module function. OFF, CMP, EF1,
q
MAX
e
e CP2 (Control Pedal 2) Sets the CONTROL pedal 2 module function. OFF, CMP, EF1,
MAX
Parameters
w
CUV=
q TIM (SEAM Time)
w CUV (SEAM Curve)
MAX
w
MAX
COMP EFF1 DIST EQ EFF2
TYPE - / + Keys
TYPE
– +
Comment
p. 27).
p. 27).
Comment
Sets the time until the reverberation subsides, in
100-ms steps.
The reverberation attenuation pattern can be set to
"LNR" (reverberation is cut when the time interval
set with the "TIM" parameter has elapsed) or
"HLD"(reverberation continues for the programmed
duration).
EFF3 DLY REV TOTAL
SERIAL/PARALLEL:
1 EF2 | | EF3
Parallel connection
Values
DST, VOL,EF2,
EF3, DLY, REV
DST,VOL, EF2,
EF3, DLY, REV
DST,VOL, EF2,
EF3, DLY, REV
Values
OFF, 0.1 – 99
LNR, HLD
63