HOZAN HC-33 Instruction Manual

Demagnetizer

HC-33

Thank you for purchasing the HOZAN HC-33 DEMAGNETIZER. With proper care and

handling, this fine instrument will provide years of trouble-free operation. Please read this

entire instruction manual carefully before attempting to place this instrument in service.

Please keep this instruction manual available for reference.

Identification of parts

Power Switch

●HC-33 is for 100 V.

Do not use by any other voltages.

Rating

Frequency

Power consumption

Dimensions

Weight

Max. magnetic flux density

Steady-state current

INSTRUCTION MANUAL

DEMAGNETIZER

100 Vac

50 Hz

12 W (at steady state)

34(W)X59(H)X216(D) mm

930 g

68mT(680Gs)

1.0A

１

Power Plug

60 Hz

56mT(560Gs)

Table of Contents

Do you have a question about the HC-33 and is the answer not in the manual?

Page 1 INSTRUCTION MANUAL HC-33 DEMAGNETIZER Thank you for purchasing the HOZAN HC-33 DEMAGNETIZER. With proper care and handling, this fine instrument will provide years of trouble-free operation. Please read this entire instruction manual carefully before attempting to place this instrument in service.
Page 2 Warning and caution symbols These symbols are used throughout the instruction manual to alert the user to potential safety hazards as follows :  Warning … Notice when incorrect handling could cause the user's death or serious injury.  Caution … Notice when incorrect handling could cause injury to the user or material damage.
Page 3 Distance and magnetic flux density, thermal controller The following data shows the relationships between distance and magnetic flux density. Measurement apparatus : Gauss meter : GM-4000 manufactured by Electromagnetic Industries Co., Ltd. Sensor probe : T22078 manufactured by Electromagnetic Industries Co., Ltd. Distance (mm) Regarding thermal controller This has an automatic thermal controller which limits the power and magnetism will fall to...
Page 4 It can not be demagnetized enough when used against a tool or a little part. In case of this, close the HC-33 and the object as near as possible, then while push- ing the power switch, gradually pull the HC-33 away from the object approximately 30cm, and release the switch.