Putting On The Fall Detection Pendant - ADT Health Fall Detection Pendant User Manual

Putting on the Fall Detection Pendant

1. Place the Fall Detection Pendant around your neck and adjust the lanyard so that
it rests at chest level with the Pendant facing away from your body so that it is
easier for you to press.
2. Wear the Fall Detection Pendant outside your shirt, as wearing it inside your shirt
can reduce the percentage of falls being detected.
NOTE:
 Please handle your Fall Detection Pendant with care when putting it on or
taking it off, as the device may interpret this movement as a fall and activate.
 If the Fall Detection Pendant does sense a fall, it sounds a series of beeps and
the red light begins flashing.
 You can cancel the Fall Detection alarm by pressing and holding the blue
Emergency Help Button on the Fall Detection Pendant for approximately 5
seconds until the light flashes green once and you hear a series of beeps.
 If you are unable to cancel, please tell the operator that it was a false alarm.
If you do not respond or speak to the operator, emergency help will be
dispatched.
Fall Detection Pendant User Guide 7