Table of Contents
Advertisement
6
Set the Key Position
You can attach the MPO inspection tips to the probe with the MPO key
on the left or right. This lets you rotate the probe when a cabinet door or
other surface is in the way of the probe's handle.
The fiber numbers in your test results will agree with the numbers for the
MPO connector when you meet these two conditions:
•
You set the Key Position at the bottom of the Live View screen to the
key position you use on the probe.
•
The bulkhead adapter or the adapter you use to connect to a patch
cord has opposed key positions (key up/key down).
7
Inspect Endfaces
•
To capture and analyze an image of an endface, press
the image, then press
•
To see the Live Image again, tap
•
If you rotate the adapter tip on the probe, tap Key Position to change
the setting.
Patch cord
Adapter
T
or tap Test.
B
or tap Live.
A
to focus
CL04.PDF
7
Advertisement
Table of Contents
