Clean The Product; Charge The Battery - Fluke DS701 User Manual

DS701, DS703 FC
Users Manual

Clean the Product

To prevent damage to the Product, do not use abrasives, isopropyl alcohol, or solvents to clean
the case or lenses.
Clean the case with a damp cloth and a weak soap solution. To clean the lenses, use a pressurized can of air or
a dry nitrogen-ion gun, if available, to blow off the particulates from the lenses.

Charge the Battery

Before you use the Product for the first time, charge the battery for ≥2.5 hours. See Figure 2.
New batteries are not fully charged. Make sure that the Product is near room temperature before you
connect the Product to the charger. See the charging temperature specification. Do not charge in hot or
cold areas. When you charge in extreme temperatures, battery capacity may decrease.
The battery does not charge while the Product is on even if Z shows as the battery status.
To charge the battery:
1. Turn off the Product.
2. Connect the USB A connector end of the USB cable into the USB charger.
3. Connect the USB charger into an ac wall outlet and connect the Micro B USB connector end into the Micro B
USB input on the Product.
4. Wait ≥2.5 hours for the Product to charge.
5. Disconnect the USB cable from the Product.
6. Turn on the Product.
 shows on the display when the battery is fully charged.
18
W Caution
Note
Note