Advertisement
Factory Restart:
1.
Remove batteries from the wall clock.
2.
Press one of the buttons on the wall clock at least 20 times to clear all memory.
3.
Verify that the wall clock is blank before proceeding
4.
Leave without power for 15 minutes (very important).
5.
Insert fresh Alkaline batteries into the wall clock.
6.
Do not press buttons for 15 minutes.
Atomic Wall Clock
12-Hour or 24-Hour Time Format
Display the time in 12-hour or 24-hour format
Default is 12-hour time
Use the
Program Menu
Supported Time Zones
Slide the time zone selector bar on the back of the clock to choose the time zone for your area.
This Atomic Digital Wall Clock offers four time zones:
EST= Eastern
CST= Central
MST= Mountain
PST= Pacific
The Atomic Digital Wall Clock works in North America. Outside of North America, the Atomic Digital Wall Clock
will not receive a WWVB signal, but will keep time like a quartz clock.
Time is off by hours
Check to see if the
WWVB
Clock has not received a WWVB time signal in the past 24 hours.
Reposition the Atomic Digital Wall Clock with the front or back facing Colorado.
Check that the
Time Zone
Check that the DST indicator is correct for your location (most areas observe DST so this should be ON).
Adjust the DST indicator with the DST/- button.
Large buildings, metal roofed buildings and buildings or rooms full of electrical and/or radio equipment
make it difficult to receive the WWVB time signal.
Daylight Saving Time
Dependent on your location, position of the clock in your home, and atmospheric interference, it may take
up to 5 nights for the change from Daylight Savings Time to Standard Time and vice-versa to occur.
Check for a
WWVB
Tower Icon showing on the atomic wall clock. The tower icon indicates you have
received the WWVB signal from Ft Collins CO in the past 24 hours.
Check that the clock is in the correct
Check whether the DST indicator is ON or OFF. If the indicator is OFF the clock will not change.
Check for fresh batteries. Without proper batteries, the antenna will have a harder time picking up the
signal.
Position the Atomic Digital Wall Clock in a window (with the front or back) facing Ft. Collins, Colorado and
leave for up to five nights. If you do not have a window facing this direction, position the clock near an
outside wall and point the unit in this general direction.
Manually Set Time/Date: Program Menu
Program menu buttons:
Hold the SET button to enter time set mode.
To adjust values press the WAVE/+ or DST/- buttons.
Press the SET button to confirm adjustments and move to the next item.
Press SET to exit, or wait 30 seconds without pressing buttons to return to the normal time display.
To set:
Hold the SET button for 3 seconds and the LCD will flash.
La Crosse Technology, Ltd
to switch time formats
Tower icon appears on the atomic wall clock. If not, the Atomic Digital Wall
selected correctly reflects your location.
Time
Zone.
Page 2
Advertisement
